Description
STAGE6 ROAD CHAIN LUBE - high-performance chain spray (400 ml)
STAGE6 ROAD CHAIN LUBE is a modern, fully synthetic next-generation spray lubricant for motorcycle chains of all types.
Features of Stage6 PTFE chain grease
The Stage6 chain grease features a high PTFE content and offers
- Excellent penetration
- Exceptional adhesion, even under extreme conditions
- Long-lasting lubrication, even under heavy loads and high speeds
Its outstanding lubricity, superior wear protection, and robust rust prevention ensure optimal performance and significantly extended service life for chains and sprockets.
Areas of application Stage6 chain grease
The chain spray is suitable for chains with O-X-Z rings and meets the high demands of racing and tuned engines.
Chain spray application
Preparation: Thoroughly clean and degrease the chain with brake cleaner.
Shake: Shake can vigorously to ensure even mixing.
Application: Spray evenly over the entire length of the inside of the chain.
Allow to take effect: Leave on for 10-15 minutes until the product has set properly.
Remove excess: Use a cloth to wipe off any excess lubricant from the chain’s outer side.
- Maintenance: It is generally recommended to repeat this every 1,000 to 1,500 kilometers.
Details Stage6 Chain Lube - Road
- PTFE chain spray
- High PTFE content
- 100% synthetic
- Suitable for all motorcycle chains with O-X-Z-R rings
- Content: 400 ml
Chain care
To ensure a long service life for chain and chain drive, you need to maintain the components with the right products.
The chain must be kept clean and lubricated to reduce wear on the chain and sprockets and to ensure that the chain moves smoothly.
How do you maintain a motorcycle chain?
- Wire brush
- Chain cleaner
- Special brush for cleaning the chain
- Chain grease
- Bike stand
Proceed as follows:
- Place the motorcycle on a stand to take the weight off the rear wheel
- Brush off with a wire brush, especially on off-road bikes where the dirt covers the chain
- Spray on chain cleaner while turning the wheel
- Brush off with the special chain brush while turning the wheel
- Repeat steps 3 and 4 until the chain is clean
- Spray on chain grease while turning the wheel
ATTENTION: For cross and enduro bikes, you should use a special off-road chain grease!
SECTION 2 : POSSIBLE HAZARDS
2.1. Classification of the substance or mixture
Complies with Regulation (EC) No 1272/2008 and its adaptations.
Aerosols, category 1 (Aerosol 1, H222 - H229).
Irritant effect on skin, category 2 (Skin Irrit. 2, H315).
May cause allergic reactions (EUH208).
Specific target organ toxicity (single exposure), Category 3 (STOT SE 3, H336).
Aspiration hazard, Category 1 (Asp. Tox. 1, H304).
Chronically hazardous to the aquatic environment, Category 2 (Aquatic Chronic 2, H411).
2.2. Labeling elements
The mixture is an aerosol with a sealed spray device.
Complies with Regulation (EC) No 1272/2008 and its adaptations.
Hazard pictograms :
GHS02 GHS07 GHS09
Signal word :
DANGER
Product identifiers :
EC 927-510-4 HYDROCARBONS, C7, N-ALKANES, ISOALKANES, CYCLICS
Additional labeling :
EUH208 Contains REACTION PRODUCTS OF BIS(2-METHYLPENTAN-2-YL) DITHIOPHOSPHORIC ACID
WITH PHOSPHORUS OXIDE, PROPYLENE OXIDE AND AMINES, C12-14 ALKYL (BRANCHED).
May cause allergic reactions.
Hazard statements :
H222 Extremely flammable aerosol.
H229 Pressurized container: may burst if heated.
H315 Causes skin irritation.
H336 May cause drowsiness and dizziness.
H411 Toxic to aquatic life with long lasting effects.
- Made under license of European Label System® MSDS software from InfoDyne - http://www.infodyne.fr -
Quick-FDS [19489-41975-12634-013865] - 2021-05-10 - 11:39:35
Date : 19/12/2018 Page 2/11
Revision : No. 4 (19/12/2018)
EC SAFETY DATA SHEET (REGULATION (EC) n° 1907/2006 - REACH)
Version : No. 1 (19/12/2018)
IPONE
Safety precautions - General :
P101 If medical advice is needed, have container or label
have container or label at hand.
P102 Keep out of the reach of children.
Precautionary statements - Prevention :
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources
Other ignition sources. Do not smoke.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P271 Use only outdoors or in a well-ventilated area.
Safety precautions - Storage :
P405 Keep locked up.
P410 + P412 Protect from sunlight and do not expose to temperatures exceeding 50 °C/122 °F
to temperatures above 50 °C/122 °F.
Safety precautions - Disposal :
P501 Dispose of contents / tray in accordance with local regulations.
2.3. Other hazards
The mixture does not contain any "substances of very high concern" (SVHC) >= 0.1 % published by the European Chemical
Agency (ECHA) according to the Article 57 of REACH: http://echa.europa.eu/fr/candidate-list-table
The mixture does not meet the criteria applied to PBT and vPvB mixtures, according to Annex
XIII of the REACH Directive (EC) No 1907/2006.
| PTFE Chain Lube Stage6 400ml | |
|---|---|
| Article no. | S6-0225 |
| EAN | 4051272046810 |
| Weight | 0,41 kg |
| Brand | Stage6 |
| Product type | Chain care |
