Description
Chain Sprocket Chainring Beta RR 125 4T
We offer you this AFAM chain set 14x63 Beta RR 125 LC Motard / Enduro to replace the worn original chain or to change the final drive ratio.
Technical data:
- Chainring bore: 100mm
- Chainring: 4 holes
- Number of chain links: 142
- Sprocket: 14 teeth
- Chainring: 63 teeth
- Chain type: 428
Useful tips:
The chain set must be replaced if the teeth of the sprocket become too sharp or if the chain has excessive play or hard spots. Wear can also be detected when the chain links become thinner and thinner and show severe flattening.
After installing the new chain kit, the tension of the chain must be adjusted correctly.
Caution: We strongly recommend comparing the chain kit with the currently installed parts (especially the chainring) using the photo and the information listed above.
Complete chain Kit
The chain set includes the main components of the chain drive, which are used to transmit the engine power to the rear wheel. Chain kits consist of the following parts: Front sprocket, rear sprocket and chain. You can buy these parts separately or as a complete chain set.
How can I tell that my chain set needs to be replaced?
There are several signs that may indicate that a chain kit needs to be replaced:
- Metallic rattling
- Worn sprocket teeth
- Loose chain that can no longer be properly adjusted
- Difficulty shifting gears or accelerating
- Signs of rust on the chain or sprockets
It is recommended to regularly check and maintain the condition of the chain kit and replace it if there are visible signs of wear.
gear ratio
The transmission ratio of the chain drive is the ratio between the front and rear sprocket. It is calculated as follows: Number of teeth of rear sprocket / Number of teeth of front sprocket. A low ratio increases speed, a high ratio increases acceleration.
Example: 15-tooth front sprocket and 53-tooth rear sprocket: 53/15 = 3.53 gear ratio